12/03/2011

Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump with Line Cord, Timer, Check Valve, and Thermo Review

Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump with Line Cord, Timer, Check Valve, and Thermo
Average Reviews:

(More customer reviews)
Yes it works ... sort of. Installation was easy using stainless braid flex lines and since it went under the kitchen sink where power was already available no wiring was needed, otherwise it would have been a major hassle. It seems well made and runs quietly.
The problem is that the hot water line under the house cools faster than the line under the sink where the pump & thermostat are located. The upshot is that instead of instant hot water, you get nearly instant warm water. It does help and the hot water warms faster than without it but if you're looking for fully hot water in a matter of seconds, you'll be dissapointed. It's an improvement but not the total solution I was hoping for.
Probably insulating the hot water line where possible in the crawl space would help. Guess I'll try that next.

Click Here to see more reviews about: Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump with Line Cord, Timer, Check Valve, and Thermo

The Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump is installed under the sink or faucet farthest from the water heater -- where hot water usually takes the longest amount of time to arrive.A built-in temperature sensor automatically turns the Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump on when the water temperature in the hot water supply line cools down to 85; F. This cool water in the hot water supply line is then pumped into the cold water line and back into the water heater.The Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump turns off automatically when the hot water supply line to the faucet reaches 95; F, ensuring the instant availability of shower warm water with maximum temperature hot water only seconds behind. When the pump is automatically turned off by the built-in thermostat, an auto closure device prevents hot or cold water from mixing in either supply line.Hot water will also be instantly available at all other faucets in the supply line between the water heater and the faucet where the AutoCirc pump is installed.Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump Features:; AutoCirc saves the average family a minimum of 15,000 gallons of water annually. ; AutoCirc saves money and pays for itself in a short period of time (see Energy Savings Chart) ; AutoCirc is silent during operation. ; AutoCirc has a built-in 24-hour timer, which allows selection of system operating periods to suit your living pattern. ; AutoCirc requires only 33 watts -- 0.3 amps of power. ; AutoCirc costs only pennies a day to operate. ; AutoCirc comes complete with a built-in 6-ft. long cord with plug for connection to a standard 115-volt outlet.Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump has Only 7 Basic Installation Steps:; Select sink under which the AutoCirc should be located (Sink where hot water takes longest to arrive). ; Install a 115 volt outlet under sink or run cord to outlet near sink. ; Turn off angle stops valves and d

Buy NowGet 39% OFF

Click here for more information about Laing ACT-303-BTRW AutoCirc Retro-Fit Circulator Pump with Line Cord, Timer, Check Valve, and Thermo

No comments:

Post a Comment